When the crane’s boom length or load radius falls between listed values on a load chart, the operator must _____.
a. select the next-shorter boom or load radius to determine crane capacity
b. select the next-longer boom or load radius to determine crane capacity
c. interpolate between the known capacity in proportion to the configuration value
d. change the crane configuration to agree with the load chart's printed boom angle or load
radius
b. select the next-longer boom or load radius to determine crane capacity
You might also like to view...
When measuring the total indicated runout (TIR) of a driveshaft, you record 0.003" (0.08 mm) positive and 0.005" (0.13 mm) negative through one shaft revolution. What is the TIR?
A. 0.015 inch (0.05 mm) B. minus 0.002 inch (minus 0.05 mm) C. 0.008 inch (0.21 mm) D. 0.002 inch (0.05 mm)
Explain why automobile manufacturers color code wires in the electrical system.
What will be an ideal response?
____ fits are typically associated with selective assembly.
A. Interference B. Transition C. Clearance D. Bilateral
A grinder can catch on rough material edges and shift around, especially when using rotary bits called _____
a. burr bits b. backing bits c. kerf bits d. saber bits