Technician A says that the back of all engine bearings should be lubricated during assembly. Technician B says that the face of the main and rod bearings should be lubricated before final assembly. Who is right?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
B
You might also like to view...
A highway truck crane is equipped with two engines, one for propulsion and the other to run the auxiliary equipment. What is the numeric SA of the auxiliary engine controller on the J1939 bus??
A. ?00 B. ?01 C. ?128 D. ?130
Which ASE certification test qualifies truck technicians to work on air brake systems?
A. T1 B. T3 C. T4 D. T5
What is the lower cut off frequency in an RLC resonant circuit if the inductive reactance is 1.2 k?, the resonant frequency is 22 kHz and the resistance is 60 ??
A) 20.9 kHz B) 21.7 kHz C) 21.5 kHz D) 21.8 kHz
The proper way to discharge a capacitor is to:
A) Apply 230 V to the terminals for a short period of time. B) Short across the terminals with a large, insulated screwdriver. C) Connect a jumper wire across the terminals. D) Connect a bleed resistor across the terminals.