A circuit with excessive current flow ________
A) May cause a fuse to blow B) May create excess heat in conductors
C) Both A and B D) Neither A nor B
C
You might also like to view...
Which of the following would not be a factor when setting up an air handler's ECM motor control to deliver the correct airflow in all operating modes?
a. System cooling capacity. b. Number of heating stages. c. Continuous fan operation. d. Fuel gas heat content.
On an OBD II vehicle, when the ignition key is on and the engine is not running, the MIL should:
A. be off B. be illuminated C. flash and then go out D. be flashing
?Which factor is strongly influenced by head loss in design of an earth loop system?
A. ?minimum fluid temperature B. ?serial or parallel piping layout C. ?type of piping that may be used D. ?required circulator power
ASE-Style Multiple Choice While having a discussion, Technician A says that you should always spray lacquer over the top of enamel. Technician B says that if this is done, the enamel could lift and cause problems. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B