?What is the minimum acceptance criteria for root reinforcement for visual inspection of butt welds?

A. ?3/32 in (2.4 mm)
B. ?1/16 in (1.6 mm)
C. ?1/8 in (3.2 mm)
D. ?no reinforcement allowed


Answer: C

Trades & Technology

You might also like to view...

To discourage unauthorized entry, handhole covers must be _____.

a. permanently sealed b. provided with a keyed access device or padlock c. heavier than 100 pounds or require tools to open d. equipped with an anti-tamper device such as an audible alarm

Trades & Technology

One of the very oldest of the clear finishes is ____________________

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A technician attaches one lead of a digital voltmeter to the ground terminal of the TP sensor and other meter lead to battery negative terminal. The ignition is turned on, engine off and the meter displays 37.3 mV. Technician A says that this is the signal voltage and is a little low. Technician B says that the TP sensor ground circuit has excessive resistance. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

The steps to connect PVC and CPVC pipe include:

A) Apply the solvent and then fit the pipe. B) Prime, fit, and then apply solvent. C) Clean, prime, apply solvent, and fit the pipe. D) Fit, clean, prime, and apply the solvent.

Trades & Technology