Heat flows from the product into the evaporator because:
A) The refrigerant in the evaporator has fewer BTU/lb than the product.
B) The refrigerant in the evaporator has a lower specific heat than the product.
C) The evaporator is at a lower pressure than the product.
D) The evaporator is at a lower temperature than the product.
D
You might also like to view...
A Mod-1000 counter requires a chain containing ______ T-FF’s.
Fill in the blank(s) with the appropriate word(s).
Blocks are inserted xrefs are:
a. linked b. attached c. referenced d. hyperlinked
In a 2-wire bulb circuit there is voltage on the feed side and the ground side with the circuit turned on. The bulb is not lit. Which of these is the most likely cause?
A) Open ground circuit B) Bad lighting switch C) Shorted ground circuit D) Bad bulb
When welding stainless-steel pipe in the 5G position, start the welds _____
a. at the top of the pipe b. at the bottom of the pipe c. 45 degrees from the top d. 90 degrees from the top WELDING LEVEL THREE MODULE 29306-16 EXAM 3 Copyright © 2016 NCCER. Permission is granted to reproduce this page provided that copies are for local use only and that each copy contains this notice.