Which of the following is required to reprogram a Volvo or Mack twin-actuator EUI calibration code?
A. single digit alpha code
B. two-digit numeric code
C. four-digit numeric code
D. six-digit numeric code
Answer: C
You might also like to view...
Which of the following describes a Myers hub?
a. A type of duct system b. A gasketed locknut c. A gasketed fitting d. An insulated bushing
The weight of a piece of lumber is 2 lb. The weight of the same piece after it is fully dried is 1.8 lb. What was the original moisture content in the wood?
A) 9% B) 7% C) 15% D) 11% E) None of the above
Most vapor charging is done with the compressor operating while charging is taking place; however, liquid charging:
A) Is always done with the compressor off. B) Is typically done on smaller systems with the system on. C) Can be done either with the system off or operating. D) Is always done with the compressor on.
When checking alignment angles, what should the technician look for?
A) The camber on the left and right should be within 0.5 degree of each other B) All angles within factory specifications C) The castor on the left and right should be within 0.5 degree of each other D) All of the above