The larger line in an air-to-air split-system heat pump is known as the ____ line.
A. vapor
B. liquid
C. transient
D. gas
Answer: D
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. A straightness tolerance is a geometric tolerance that defines the straightness deviation permitted on individual surface elements or on a derived median line. 2. Wherever Rule #1 applies to a cylindrical feature of size, it invokes an indirect straightness deviation requirement on the surface elements. 3. Although Rule #1 provides an indirect straightness tolerance, a straightness tolerance should be specified on surface elements, unless it is a refinement of the dimensional limits of the size dimension (i.e., size tolerance). 4. Wherever Rule #1 applies to a cylindrical regular feature of size, an indirect straightness deviation requirement exists for the derived median line of the feature of size. 5. Where a straightness tolerance is applied to a surface element that is associated with a size dimension, and Rule #1 does not apply to the size dimension (i.e., overridden, independency, stock size, etc.), the straightness tolerance value may be smaller than the size tolerance.
There are relatively few disease problems with llamas and alpacas
Indicate whether the statement is true or false
Which of these is LEAST likely to be used to lift a vehicle in a professional shop?
A) Floor jacks B) Two post frame engaging hoist C) Drive-up ramps D) None of these
When a mobile crane is being moved without direction from the rigger, three travel signals from the crane's
horn mean the _____. a. boom is rising b. crane is stopping c. crane is moving forward d. crane is traveling in reverse