Sheet P-1 is the __________ section.

Fill in the blank(s) with the appropriate word(s).


plumbing

Trades & Technology

You might also like to view...

Additional drawings, called detail drawings, usually accompany:

A. An assembly drawing B. A scale drawing C. A casting drawing D. A revised drawing

Trades & Technology

Flat taper may be specified as:

A. flat taper per inch, flat taper as a ratio, or conical taper B. flat taper per inch, flat taper as a ratio, or flat taper in degrees C. flat taper per inch, Morse taper, or flat taper as a ratio D. ?

Trades & Technology

When making a current measurement with a VOM meter, you should ________

A) create an open in the circuit and place the meter probes so that the meter is in series with the load B) place the meter probes across the load C) turn off all power to the circuit during the current reading so you don't get shocked

Trades & Technology

Fluid can return through the metering valve when the brakes are released.

Answer the following statement true (T) or false (F)

Trades & Technology