"FIM" is an acronym for ____.
A. feature indication maximum
B. form illustration maximum
C. full indicator movement
D. form indicator movement
E. none of the above
Answer: C
You might also like to view...
What type of lubricant uses a moving member?
A. Forced feed B. Splash feed C. Wick feed D. Gravity feed
In a brick veneer assembly, weep holes are required
A) at each alternate floor level. B) immediately above the flashing. C) at each floor level. D) 2 in. above a flashing. E) immediately below the flashing.
Which of the following procedures would adjust the phase angle of one pump element in a port-helix metering injection pump?
A. shimming the fuel pump drive gear B. rotating the barrel C. shimming the barrel flange D. repositioning the control rack
The condition of a battery cable end (where it connects to the battery post) is questionable. Technician A says a battery leakage test will determine the quality of the connection. Technician B says a battery terminal voltage drop test can be used to determine the quality of the connection. Who is correct?
A. Technician A only B. Technician B only C. Both Technician A and B D. Neither Technician A nor B