Match each item with a statement below.
A. A CSIRT staffing model where an organization performs all its IR work
B. A CSIRT staffing model used when an organization does not have enough qualified employees
C. Equipment needed to detect and manage incidents
D. An incident response philosophy that focuses on the defense of data and systems
E. An incident response philosophy that focuses on the identification and apprehension of the intruder
F. Examples of this are monitoring security-related mailing lists and researching new rootkits that are publicly available
G. Measurement used for comparison of past security measures and current CSIRT efforts
H. Should be included in the announcement of an operational CSIRT
I. A critical nontechnical skill for CSIRT members
A. employees
B. fully outsourced
C. packet sniffer
D. protect and forget
E. apprehend and prosecute
F. technology watch
G. response time
H. operating hours
I. teamwork
You might also like to view...
Problem 1.53 In the steel structure shown, a 6-mm-diameter pin is used at C and 10-mm-diameter pins are used at B and D. The ultimate shearing stress is 150 MPa at all connections, and the ultimate normal stress is 400 MPa in link BD. Knowing that a factor of safety of 3.0 is desired, determine the largest load P that can be applied at A. Note that link BD is not reinforced around the pin holes.
Which of these heat exchangers in an automotive A/C system is located at the front of the vehicle?
A) Condenser B) Evaporator C) Heater core D) None of these are mounted at the front of the vehicle
The big end of the rod is considered to be ________
A) Reciprocating weight B) Inertia weight C) Rotating weight D) Both A and B
If aluminum power wire is used, to make a safe connection the installer should make sure
A) That the furnace power connectors are rated for aluminum wire B) to first spray the lugs with insulating spray C) The aluminum wire is one size smaller than a comparable copper wire D) to use an aluminum tipped screwdriver to tighten the lugs