During shop equipment maintenance or repair, the service consultant’s job is ________
A. Nothing, he/she does not have a role
B. Adjust for delays and reschedule appointments as needed
C. Assist with the maintenance and/or repair of the equipment
D. Authorize and enter a contract on behalf of the service facility owner
A. Nothing, he/she does not have a role
You might also like to view...
Using a process known as ____, network-based IDPSs look for attack patterns by comparing measured activity to known signatures in their knowledge base to determine whether or not an attack has occurred or may be under way.
A. packet sniffing B. port monitoring C. traffic measurement D. signature matching
Which of the following is not part of the operating sequence of a natural-draft furnace?
a. The draft inducer starts on a call for heat. b. The controls prove that the pilot is lit. c. The gas valve energizes and opens. d. The fan switch starts the blower.
To insure that the rafters or joists do not interfere with installation of the plenums on a curb mounted rooftop unit
A) The roof curb must be installed diagonal to the roof joists or rafters B) The roof curb must be square with the roof joists or rafters C) The roof joists or rafters are cut out where the curb is installed D) The plenums are fabricated in place with the roof joists or rafters passing through them
Two technicians are discussing power adders. Technician A says that superchargers are belt driven. Technician B says that turbochargers are belt driven. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B