Technician A says the flywheel is attached to the engine crankshaft and rotates at engine speed. Technician B says the pressure plate also rotates at engine speed. Which technician is correct?
A) Technician A only B) Technician B only
C) Both Technicians A and B D) Neither Technicians A nor B
C
You might also like to view...
The width of an expansion joint in the rails of a typical stick-built glass curtain wall _________.
A) is 1/32 in. standard. B) is 1 in. standard. C) is 1/2 in. standard. D) is 1/4 in. standard. E) must be determined on project-by-project basis.
Calculating the number of masonry units involves a ____-stage process
A. two B. three C. four D. six
Based on their position relative to the welding symbol, welds are referred to as:
A. The top and bottom welds B. Butt welds or lap welds C. Arrow side and other side welds
A rounded edge is usually specified:
A. To improve the appearance of a part B. To reduce the chances of injury caused by a sharp edge C. To prevent interference or chipping D. All of the above are reasons for specifying a rounded edge