A rounded inside corner is known as a(n) ____.
A. chamfer
B. arc
C. radius
D. fillet
Answer: D
You might also like to view...
Which of the following is a true statement regarding the circuit shown below?
A. The resistance value (ohms) of the resistor influences the amount of time for the capacitor to charge. B. The capacitance value (farads) influences the amount of time for the capacitor to charge. C. Moving the switch from position 1 to position 3 would cause the direction of current flow through the resistor to reverse. D. All of the above are true statements.
A procedure used to review job methods and uncover hazards that may have been overlooked is _____.
a. Job Safety Analysis (JSA) b. Critical Incident Analysis (CIA) c. Site Environment Analysis (SEA) d. Task and Job Analysis (TJA)
Technician A says that completing an entire four year apprenticeship program satisfies the ASE work requirement. Technician B says that a year of school equals an hour of work experience. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Technician A says that suspension diagnosis and service should begin with a comprehensive test drive. Technician B says that shocks or struts should be replaced in axle pairs. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician