In a J-K flip-flop, the SET state occurs when
A) J is low, K is high, and there is a triggering clock edge.
B) J and K are low and there is a triggering clock edge.
C) J is high, K is high, and there is a triggering clock edge.
D) J is high, K is low, and there is a triggering clock edge.
D
You might also like to view...
What is one time constant for a 10 mH inductor connected in series with a 47 k? resistor?
A) 0.213 ?S B) 470 mS C) 213 ?S D) 470 S
RC integrators can be used to convert a repetitive pulse waveform to a constant dc voltage equal to the average voltage of the waveform if:
A) ? is very large compared to tW. B) ? is very small compared to tW. C) ? is equal to tW. D) ? is five times tW.
The top surface of an insert should be positioned below the concrete panel surface by _____
a. 1/16" b. 1/8" c. 1/4" d. 3/8"
A _____ is an electrical circuit that contains two or more paths for the electricity or signal to flow from a common source.
A. ground fault circuit interrupter B. receptacle C. single-pole circuit D. parallel circuit