What should you look out for where standoffs are used when installing transistors? What if the leads are clinched?

What will be an ideal response?


Where a standoff is used to install a transistor, make sure that standoff is the right side up and the feet of the standoff are on the board. If the leads are clinched, they are clinched away from the center of the body of the transistor.

Trades & Technology

You might also like to view...

In 1985, the _____ was established to pay farmers to set aside farmland

a. Pollution Control b. Farm Safe c. Crop Reserve Program d. Conservation Reserve Program

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. An engineering drawing is an important document in an organization because it affects the success of both the product and the organization. 2. The function of a product determines the amount of variation permitted for each dimension. 3. Engineering drawings cannot be used as evidence in product litigation cases. 4. The ISO standards are created in the U.S., but are used globally. 5. Dimensioning and tolerancing standards are used on most engineering drawings around the world.

Trades & Technology

Where would the cost of temporary utilities be put in the estimate?

What will be an ideal response?

Trades & Technology

In the accompanying figure, c = 8.7 mm and b = 3.4 mm. What is a to two decimal places?

A. 8.01 mm B. 8.34 mm C. 8.65 mm D. 8.70 mm

Trades & Technology