Starters that are intended to protect motors that operate on 240 volts should contain four load contacts.
Answer the following statement true (T) or false (F)
False
You might also like to view...
With separate contracts, describe three options available to the owner for managing the contractor’s work on the project.
What will be an ideal response?
Los rollos de láminas de revestimiento se deben almacenar _____.
a. en un edificio húmedo b. planos c. en un ángulo de 90° d. sobre un extremo
Answer the following statement(s) true (T) or false (F)
1. The pilot control device shuts down at a loss of power. 2. The phrases no-voltage drop-out, or two-wire control circuit should indicate a possible safety concern to the electrician, because a mechanically held closed pilot device could automatically restart the load motor when the power is restored. 3. A differential control device is a two position (on/off) switch that actuates when the measured medium reaches either of the two pre-determined extreme high or low range values, with a dead zone in between where the switch does not change states. 4. It is extremely uncommon to find differential switches for pilot devices in these motor control circuits. 5. Differential controls provide a mechanical means that acts like a mechanical holding circuit.
________ is the ratio of the pulse width to the period and has no units
Fill in the blank(s) with correct word