In an insulated wall metal panel, the insulation is sandwiched between __________.

A) a metal sheet on both sides.
B) a metal sheet in the front and an acrylic sheet at the back of the panel.
C) a metal sheet in the front and a fiberglass scrim at the back of the panel.
D) none of the above.


A) a metal sheet on both sides.

Trades & Technology

You might also like to view...

When selecting a conductor for a remote control lighting system, what type of conductor is typically used? What do you need to consider when selecting a wire gauge?

What will be an ideal response?

Trades & Technology

Contractors are usually advised in the "____" to satisfy themselves as to the present condition of the site.

A. Notice to Bidders B. Notice to Contractors C. Instructions to Bidders D. Instructions to Contractors

Trades & Technology

PROBLEM 3.113 Three points on the nonlinear stress-strain diagram used in Prob. 3.112 are (0, 0), (0.0015, 55 MPa), and (0.003, 80 MPa). By fitting the polynomial through these points, the following approximate relation has been obtained. Solve Prob. 3.113 using this relation, Eq. (3.2), and Eq. (3.26). PROBLEM 3.112 A 50-mm diameter cylinder is made of a brass for which the stress-strain diagram is as shown. Knowing that the angle of twist is 5? in a 725-mm length, determine by approximate means the magnitude T of torque applied to the shaft.

Trades & Technology

One of the most critical parts of structural steel drawing is the calculation of dimensions

Indicate whether the statement is true or false

Trades & Technology