For making accurate cuts across the narrow dimension of gypsum board, always use a _____
a. T-brace
b. utility saw
c. hook-bill knife
d. T-square
d
You might also like to view...
Describe the differential movement during acceleration on a live-axle rear suspension system, and explain how this action occurs.
What will be an ideal response?
These types of views are established by placing viewing plane lines identifying where the view is taken. Each end of the viewing plane line is labeled with a letter, such as A for the first view and B for the second view. Consecutive letters are used for additional views. The view is then found somewhere on the print, and a title is placed below the view to correspond with its viewing plane line label, such as VIEW A-A.
a. auxiliary view b. detail view c. partial view d. removed view
An advantage of a ____ is that the brace, being flush with the face of the studs rather than placed between them, does not interfere with the installation of insulation or electrical wiring.
A. let-in brace B. soleplate-top plate brace C. continuous brace D. diagonal brace
In the accompanying figure, the item identified as A indicates the ____ lines.
A. phantom B. cutting plane C. hidden D. break