A shift-by-wire system uses ________ and ________ to control the operation of the automatic transmission/transaxle.
A) Push buttons; dials
B) Electronic shifter; actuator
C) Solenoids; relays
D) Wires; cables
B) Electronic shifter; actuator
You might also like to view...
What will happen in a circuit if the voltage does not change but the resistance in the circuit increases?
What will be an ideal response?
The MIL is turned off under any of the following conditions, EXCEPT ________
A) PCM diagnostic link is grounded B) Codes are cleared with a scan tool C) Power to the PCM is disconnected D) Vehicle is driven on 3 consecutive trips with a warm-up cycle, without detecting a fault
When testing an oxygen sensor using a digital storage oscilloscope (DSO), how quickly should the voltage change when either propane is added to the intake stream or when a vacuum leak is created?
A) 1-3 seconds B) 100-200 ms C) Less than 100 ms D) 450-550 ms
A load demand change will alter the value of a controlled variable.
Answer the following statement true (T) or false (F)