Which of the following is a method used to find points in the 3D space?
a. Point filters
b. AutoTrack
c. Direct entry method
d. All of the above
D
You might also like to view...
Before pulling a piston from a cylinder bore, which of the following is recommended?
A. remove the crankshaft B. pull piston through the bottom of the liner C. clean up the liner carbon ridge D. remove the main bearing cap
(a) Determine the member end moments for the rectangular ring in Figure P10.12, and draw the shear and moment curves for members AB and AD. The cross section of the rectangular ring is 12 in. × 8 in. and E = 3000 kips/in. 2 . (b) What is the axial force in member AD and in member AB?
Hint: take advantage of symmetry to simplify the analysis by slope deflection.
When rotating tires on a vehicle equipped with TPMS Technician A says that the sensors will be automatically relearned after driving a few miles. Technician B says that the sensor positions should be relearned, using a scan tool, before returning the vehicle to the customer. Who is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Fractions are as commonly used on engineering prints as decimal inches or millimeters.
Answer the following statement true (T) or false (F)