The typical TTL output circuitry is referred to as
A) saturation. B) totem pole. C) inversion. D) cutoff.
B
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The flat track repair can be made using either pieces of track from a similar type of board that has been scrapped or from commercial pieces of plain or tinned copper. 2. When the break is in excess of 1/8" (3.18 mm), it is recommended that the track being repaired be cut at 45°. 3. It is more difficult to hold a round wire in place onto a rounded surface. By slightly flattening the wire with serrated needle-nosed pliers, it will be easier to hold the wire in place. 4. The funnellette provides the most reliable type of repair for a double-sided board. 5. The soldering process should include the flow of solder from the lead to the eyelette to the pad, on both sides of a double-sided board.
Which of the following statements is true about Type MC cable in patient care spaces?
a. Any Type MC cable can be used in patient care spaces. b. Type MC cable with a health care facility rating must be used. c. Type MC can be used in sleeping spaces but not in bathrooms. d. Type MC cable is most commonly used in critical care units.
Fire-rated doors are ____ allowed to have a slightly lower rating than the walls in which they are installed.
A. seldom B. often C. always D. never
Most bison producers use branding as a method of identification.
Answer the following statement true (T) or false (F)