Weld neck flanges must be marked with the weight so the _____ will match.
a. bores
b. outside diameters
c. length of the neck
d. shapes
a. bores
Trades & Technology
You might also like to view...
The ____________________ is the distance between the original surface of the joint and the deepest point of fusion.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Consider the circuit in Fig. 2.118. Find the equivalent resistance at terminals:
(a) a-b, (b) c-d.
 FIGURE 1.png)
Trades & Technology
The minimum cut when machining a drum should be ______
A) 0.020 inch B) 0.002 inch C) 0.0005 inch D) 0.600 inch
Trades & Technology
Which of the following is not a method used to define the structure of the DS-3 signal?
A) clear channel B) C-bit parity format C) M23 framing format D) ESF
Trades & Technology