Which of the following is the path to the Sum button?
A. (Editing tab | Home group)
B. (Home tab | Editing group)
C. (Home tab | Clipboard group)
D. (Calculation tab | Editing group)
Answer: B
You might also like to view...
Why do programmers use comments?
What will be an ideal response?
Configure the network routers (R1 and R2) and computers PC1 and PC2 to operate in the network using the IP addresses, subnet masks, and gateway addresses specified in Table 1. You are to also configure Routing Information Protocol (RIP) routing between the two networks.
1. Configure the IP address and subnet masks for Routers R1 and R2 and PC1 and PC2. List the steps taken to accomplish this task. List the router prompts and commands for each task.
2. Configure RIPv2 routing for the network. List the router prompts and commands to accomplish this task.
3. Verify that the network routing is properly configured. Discuss the steps you took to accomplish this. Make corrections to the network configurations as needed.
4. In this step, you will create an ACL on Router R1 that filters all User Datagram Protocol (UDP) traffic coming into the serial 0/0/0 interface on Router R1. You will also allow all other traffic, including Internet Control Message Protocol (ICMP), to enter the network. You can simulate UDP traffic by issuing the traceroute command, and you can simulate ICMP traffic by issuing the ping command. Given this information, create an access list that meets this requirement. Note that when testing your access list you will issue the traceroute and ping commands from Router R2
After a worksheet has been displayed in Page Layout view, page breaks are indicated by ________ in Normal view
Fill in the blank(s) with correct word
?You can share inked pages with others using Microsoft Edge by __________.
Fill in the blank(s) with the appropriate word(s).