How are tolerance limits expressed on a drawing?
What will be an ideal response?
When the dimensions within the tolerance limits appear on a drawing, they are expressed as a range from the smaller to the larger dimension.
You might also like to view...
What are the differences in channel allocation problem in FDMA/TDMA-based system versus CDMA-based system? Explain clearly.
What will be an ideal response?
The jounce bumpers on the rear struts are severely damaged. Technician A says the rear struts may be worn out. Technician B says the rear spring may be worn. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Two technicians are attempting to locate a leak by using a pressure tester on the radiator. Technician A says to use a mirror and flashlight to locate a leak if the location cannot be seen. Technician B says to run the engine when performing the test. Who is right?
A. ?Technician A only B. ?Technician B only C. ?Both A and B D. ?Neither A nor B
Multiply the following decimal fractions: 5.24"x 0.195 =
Fill in the blank(s) with the appropriate word(s).