What is a technical catalog exploded assembly drawing?
What will be an ideal response?
Technical catalog exploded assembly drawings are drawings in which parts are aligned and represented in position for assembly.
You might also like to view...
A Hall-effect switch is being analyzed on a lab scope. The high part of the signal measures 5.0 volts. Ideally, what should the low part of the signal read?
A. 0.0 volts B. 450 millivolts C. 4.5 volts D. 2.5 volts
?The _______________ geartrain is an arrangement of two separate planetary gearsets with a common sun gear, two ring gears, and two planetary pinion carriers.
Fill in the blank(s) with the appropriate word(s).
Which standard construction documents provide forms for processing change orders?
What will be an ideal response?
Which of the statements below best describes the basic operation of a dual-slope A/D converter?
A) A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter. B) A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant V/second rate. C) Two ramps are generated: one by the input voltage and the other by a reference voltage. The input voltage ramp charges the integrating capacitor, while the reference voltage discharges the capacitor and enables the counter until the capacitor is discharged, at which time the counter value is loaded into the output latches. D) The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and is displayed on the digital display as a voltage reading.