Technician A says a transmission band is hydraulically applied by a multiple disc clutch.Technician B says that for the PCM/TCM to determine when to start a gear change, it must be able to refer to shift schedules that it has stored in its memory.Who is correct?

A. Technician A
B. Technician B
C. Both A and B
D. Neither A nor B


Answer: B

Trades & Technology

You might also like to view...

Figure 33-10A ? The above figure shows a four-speed, two-winding three phase consequent pole motor with constant ____________________.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

In a brick veneer assembly, weep holes are required

A) at each alternate floor level. B) immediately above the flashing. C) at each floor level. D) 2 in. above a flashing. E) immediately below the flashing.

Trades & Technology

Good floor-slab flatness and levelness is critical in warehouses to allow _____.

a. higher safe speeds for forklifts b. proper drainage c. greater stacking heights d. use of heavier equipment

Trades & Technology

In Prob. 16.7 the volume fraction of the precipitate was taken to be 0.001.

(a) Assuming that the precipitate consists of cementite, and the the densities of cementite and ferrite are nearly equal, estimate the carbon concentration in the iron. (b) Would it be possible to get this much carbon in solution at 1000 K? In other words, could one reasonably expect to obtain a 0.001 volume fraction of cementite precipitate on aging just above 300 K after a rapid quench from 1000 K?

Trades & Technology