Floor plans are a representation of a horizontal cut made approximately 4' (1220 mm) above the floor line.
Answer the following statement true (T) or false (F)
True
You might also like to view...
An engineer has been given the assignment of finding how much money can be saved over a year’s time by redesigning the press plates from the pattern shown in Figure 4.18a to the pattern shown in Figure 4.18b for stamping out 2.400 in. diameter disks. The stamping material is 14-gauge sheet metal and can be purchased in 100 ft rolls in varying widths in 0.5 in. increments. One square foot of metal weighs 3.20 lb. The metal is sold for $0.20/lb. Do not consider the ends of the rolls. The company expects to produce 38 000 parts this year. How much can be saved?
 FIGURE 1.png)
An advantage of the RTM process is that ____. ?
A. ?it minimizes material waste B. ?polymers may be reinforced C. ?good finishes can be expected D. ?there are fast cycle times for large products
The clutch_______ applies pressure to the clutch plates and friction discs.
A. drive pulley B. pressure plate C. center ramp D. judder spring
A system is described by 
Classify the system as to linearity, time invariance, memory, causality, and stability.
What will be an ideal response?