Steels alloyed with carbon and only a low concentration of silicon and manganese are known as ____________________.

Fill in the blank(s) with the appropriate word(s).


plain carbon steels

Trades & Technology

You might also like to view...

Which wire on a TP sensor should be back probed to check for a voltage signal to the PCM?

A) Ground wire
B) Meter should be connected between 5-volt reference and ground
C) 5-volt reference (Vref)
D) Signal wire

Trades & Technology

wound rotor motor has been recently put back into service but is now rotating in the wrong direction. After examining the motor, you find that lead L1 is connected to T2, L2 to T3, and L3 to T1. To correct the rotation, you should

a. Connect L2 to T1, L3 to T2, and L1 to T3. b. Connect L1 to T1, L2 to T3, and L3 to T2. c. Connect L1 to T1, L2 to T2, and L3 to T3. d. Reverse phase connections between the wound rotor and the resistor bank.

Trades & Technology

In mountain driving you will have to use a lower gear to drive safely on a grade. Which of these does NOT affect your choice of gear?

a. The length of the grade. b. Tire thread's depth. c. The weight of the load.

Trades & Technology

Technician A says that the needle and nozzle setup directions are found in the SDS for the paint being sprayed. Technician B says that needle and nozzle setup is the same for all sprayable materials. Who is correct?

A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B

Trades & Technology