When manually adjusting brakes equipped with automatic adjusters, the ________ must be pushed or held out of the way
A) Adjuster cable B) Return spring C) Adjuster lever D) Starwheel adjuster
C
You might also like to view...
Give the sizes (in inches and penny designation) of commonly used nails in wood frame construction.
What will be an ideal response?
Material that has been issued a _____ is marked with the © symbol.
A. patent B. bookmark C. trademark D. copyright
When turning to size predictably:
A) A trial cut is taken and a spring caliper is set to the size using a rule. This is sufficiently accurate for finishing most outside diameters. B) A short skim cut is taken and measured. The cross slide feed collar is zeroed and the roughing cut depth is dialed. A trial cut is taken and the crossfeed screw backed off after noting the setting. The diameter is checked, the tool is returned to the start position and the dial reset to its former position. The cut is taken. This procedure is continued to finish size. C) A short skim cut is taken and measured. The cross feed collar is zeroed, and the roughing cut is dialed. A trial cut is taken and checked and the cut is taken. This procedure is continued to finish size. D) A trial cut is taken that looks like the approximate diameter or slightly over and it is checked with a micrometer. This procedure is continued to finish the part.
Technician A says the first step in checking transmission electrical controls is to verify system voltage. Technician B says when no DTCs are present then diagnose the transmission based on its symptoms. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B