Grounded (grounding) is defined as being ____.
A. connected to ground or to a conductive body that extends the ground connection
B. located along a circuit that includes a panel board
C. connected to a bonded locknut
D. located adjacent to the main bonding jumping
Answer: A
You might also like to view...
If the previous command was G90 G00 X5 Y6 Z3, which of the following commands will cause the tool to move to (8,8,3), moving at the currently set feed rate:
A. G01 G91 X3 Y2 B. G01 G90 X3 Y2 C. G00 G90 X8 Y8 D. G01 G91 X8 Y8 Z3
The ____ relay is so named because it uses a length of resistive wire connected in series with the motor to sense motor current.
a. serial thermostat b. movable arm c. solid-state starting d. hot-wire starting
____________________ refer to standards by which designs can be created, measured, discussed, and evaluated
Fill in the blank(s) with correct word
Which of the following is not a type of assembly print used in industry?
A. detail assembly B. design assembly C. pictorial assembly D. erection assembly E. none of the above