Torque is ________.
A) The gear ratio
B) Results in motion
C) A twisting force
D) The rate of doing work
C) A twisting force
You might also like to view...
When reading a load chart, when the planned load radius falls between two values on the chart, you must _____.
a. use the next lowest value b. use the next highest value c. interpolate d. round the estimated radius to the nearest whole number
Welded wire mesh shall be measured in plan area with an additional ____% included for overlaps.
A. 5 B. 10 C. 15 D. 20
Technician A says that the RBM value of a frame is a measure of its ultimate rigidity. Technician B says that the RBM value of a frame is a measure of its ultimate strength. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Where in the text can you find websites and information about all types of certification organizations?
A) Appendix B B) Appendix D C) Appendix C D) Appendix A