Answer the following statement(s) true (T) or false (F)When operating a table saw, proper feed rate is determined by listening to the blade speed.

When operating a table saw, proper feed rate is determined by listening to the blade speed.


ANS: T

Trades & Technology

You might also like to view...

When creating a final IR plan physical document, it is suggested that the plan be stored in a binder with red and yellow or white reflective tape on the spine of the binder. Why?

What will be an ideal response?

Trades & Technology

Wires from a sensor to a ground fault relay should be no longer than _____.

a. 10' b. 25' c. 50' d. 100'

Trades & Technology

In base line dimensioning, all measurements are made from common finished surfaces called base lines or ____ lines.

A. relative B. connection C. dimension D. reference

Trades & Technology

Recompute the reactions for the frame in Figure P9.43 if support C settles 0.36 in. when the load acts and support A is constructed 0.24 in. above its intended position. Given: E = 30,000 kips/in. 2 and I = 60 in. 4 .

Trades & Technology