For an angle or U pull, the length of a pull box housing shielded conductors carrying over 600V must be how much greater than the outside diameter of the largest shielded conductor entering the box?
The zero vernier graduation lies between 3.050 and 3.075 and the vernier graduation that coincides with a main scale graduation is 21. What is the vernier caliper setting?
If you do not grind the weld profile flush after making a weld repair to a truck frame, which of the following is altered in a way that can cause another failure?
Technician A says that a DD axial power turbine (APT) uses a constant geometry (CG) turbine principle. Technician B says that DDC claim their APT can add over 100 horsepower to engine output potential. Who is correct?
Technician A says that the best way to check for a misfiring cylinder on a high-pressure common rail fuel system is to crack each injector line open one by one. Technician B says that it may be necessary to use an electronic service tool to enter new injector calibration information into the ECM memory if an injector is replaced. Who is correct?
Technician A says that a disadvantage of forged steel trunk pistons is reduced headland volume when compared with articulating pistons. Technician B says that when a diesel engine uses lighter pistons, higher rpms are possible. Who is correct?
Technician A says that all tires of the same nominal diameter have the same rolling radius. Technician B says that to determine the rolling radius of a truck tire, measure the periphery using a tape measure and divide the result into one mile. Who is correct?
Technician A says that EUPs are mechanically-actuated by a cylinder block mounted camshaft. Technician B says that SMART injectors supplied by high pressure lines are used on current EUP fuel systems. Who is correct?
When installing an oil-fired furnace in a confined space with a firing rate of 100,000 Btuh, what is the minimum free air opening required if the combustion air vents are directly communicating with the outside?
Bar graphs are the most common type of graph used where there is no causal relationship between quantities, and data where there is a causal relationship between quantities.
<img src="https://sciemce.com/files/4/ppg__cognero__UNIT_45_Solution_of_Equations_by_the_Multiplication_Root_and_Power_Principles_of_Equality__media__e97fc621-e227-4cf0-ac6d-aeecd3bfc9db.PNG" style="vertical-align: 0px;" width="192px" height="126px" />
The width of the rectangular sheet of metal shown in the accompanying figure is equal to the area of the sheet divided by its length. Compute the area of a sheet that is 3 1/4 feet wide and 5 1/2 feet long.
Technician A states static discharge is usually not an issue in a shop environment because of cement floors and rubber soled foot ware. Technician B states when working on vehicle electronic circuits you should always wear a grounding strap as a precaution. Which technician is correct?
A carbon steel ring, cut about the same size as a gasket, with a piece of soft metal, such as copper, brass, or aluminum bolted across the middle of the ring is a _____.
Compare the relaxation times, of vanadium and tantalum, due to the presence of oxygen atoms in solid solution at 400 K. The lattice parameters of vanadium and tantalum are respectively equal to 0.3029 and 0.3303 nm.