Trades & Technology - Automotive. Quiz Level 1

How much thicker than standard would a 0.020" undersized bearing insert be?

Which of the following is NOT considered an input for the suspension ECM?

Typical secondary coil resistance specifications usually range from ________ ohms

Technician A says to label the core plugs as they are removed so they can be reinstalled. Technician B says to remove the core plugs before hot tanking the block. Who is correct?

5

ASE-Style Multiple Choice A ____ or wax and grease remover, is a fast drying solvent often used to chemically clean a vehicle.

6

Why do we need a starter on an internal combustion engine?

7

Technician A says that a vehicle may have stored DTCs even if the MIL is not illuminated. Technician B says that all DTCs will illuminate the MIL. Which technician is correct?

8

The tool that would MOST-Likely be used to apply a nondirectional finish to the face of a finished rotor is:

9

Technician A says that many vehicle manufacturers recommend that wheel cylinders not be honed because of the special surface finish inside the bore. Technician B says that some experts recommend that the wheel cylinders be replaced every time the brake linings are replaced. Which technician is correct?

10

When using a DMM, the black lead usually goes in which port?

11

A micrometer can be used to measure to an accuracy of _______

12

Parameter information display (PID) is included in which OBD-II generic mode?

13

Technician Asays that worn dampers will generally bounce more than two to three times when performing a bounce test. Technician B says camber is the angle most responsible for straight tracking of the car. Who is correct?

14

What are some of the features and benefits of a digital storage oscilloscope (DSO)?

15

The solid oxide fuel cell is used to ____.

16

Most full-time AWD systems give the driver the option of 2WD or 4WD.

17

Technician Asays Type A diagnostic trouble codes are emissions related and are detected during the first trip. Technician B says Type B diagnostic trouble codes are also emissions related but require two trips to set a hard code. Who is correct?

18

Explain the procedure for measuring steering wheel free play.

19

Technician A says that the valve guides must be repaired before machining the valve seats. Technician B says that valve seats may be removed and replaced on some cylinder heads. Who is correct?

20

Electromagnetic gauges produce needle movement by ____________________ forces.

21

What is the formula for calculating torque?

22

Technician Asays a fuse should only be replaced with the same ampere rating as the original designed for the circuit. Technician B says circuit breakers can be replaced with one of a slightly lower ampere rating if the original size designed for the circuit is not available. Who is correct?