Find your answers, solutions and more...

We made it much easier for you to find exactly what you're looking for on Sciemce. Enjoy our search engine "Clutch."

Save a GPA. Donate your notes with us.

Loading...

Easy Quiz 2. Trades & Technology - Automotive

1

The W in 10W-30 viscosity oil stands for ____________________.

2

Technician A says following turbo use, turbo bearings cool quickly when the engine is shut off. Technician B says synthetic oil burns at a lower temperature so it is the oil of choice for use with a turbocharger. Who is right?

3

The amount of error allowed in the size of structural steel is 1/10 of 1%. If an I beam is 7.2 inches deep, what, in inches, is the amount of error allowed?

4

Battery charging is being discussed. Technician A says he charger should be turned off before connecting the charger cables to the battery terminals. Technician B says a battery with frozen electrolyte should be charge for 30 minutes or until the electrolyte melts. Who is correct?

5

Technician A says that a power balance test is the best way to isolate the problem cylinder. Technician B says that a compression and cylinder leakage test can help determine the cause of the problem. Which technician is correct?

6

Technician A says fuel pumps can be checked for amperage draw and current waveform. Technician B says a low amp probe is connected in series with the circuit being tested. Who is correct?

7

ASE-Style Multiple Choice ____ is used to prevent freeze-up in cold weather and to lubricate moving parts.

8

A spring-loaded seal compensates for ALL of these conditions EXCEPT:

9

Antilock brake system trouble codes are usually type ________ codes on OBD II equipped vehicles

Memory seats use the _______ to store seat position information

Which of the following is a non-verbal communication?

What two facts must be considered when designing a drive shaft?

Cotter pins should be reused if they are not damaged

Oil with a high viscosity has a ________ resistance to flow than oil with a lower viscosity

While discussing steering wheel free play:Who is correct?

In an OBD II system mode 6 is:

In ____, power comes in through the input shaft third gear, which is connected to the input shaft by the third and fourth synchro clutch.

Why does the main power relay on a Bosch Motronic fuel injection system contain a diode?

Which of these tools is MOST likely to be used to determine the starter circuit voltage drop test?

What is the purpose of height sensors?

A safety stand is also called a ________

When installing a bearing over a shaft, where should the force be applied?

When adjusting a new V-belt, set the tension about ____ pounds higher than the recommended specification.

What is the definition of a hazard?

How would you remove a "duckbill" connector?

When you apply acrylic nails, what is the use of the primer?

A malfunction indicator light on the dash may be labeled ________

Oil change intervals as specified by the vehicle manufacturer ________

Web
Analytics Made Easy - StatCounter

...