Quiz Mark 7- Trades & Technology - Automotive

1

ASE-Style Multiple Choice All of the following are included in the dash assembly EXCEPT:

2

Fabric wraps are not a good service choice for a client whose hands are frequently:

3

Which component is typically used to set rear camber in many vehicles?

4

Although some calipers will fit either side of a vehicle, they should not be interchanged because the ________

5

Engine stands ________

6

An electrical conductor is an element with ________ electrons in its outer orbit

7

Although some calipers will fit either side of a vehicle, they should not be interchanged because the ________

8

Most of today's cars are powered by _____-cycle engines.

9

A DTC P0113 DTC is being discussed. Technician A says that the IAT sensor could be internally (electrically) shorted to ground. Technician B says that the PCM could be defective. Which technician is correct?

10

Which component may be used to adjust rear camber in many vehicles?

11

On an automatic temperature control system the blower motor circuit resistance is specified at 2.0 to 3.5 ohms. If the resistance in the circuit decreases to 1.5 ohms which of the following will be the most likely result?

12

Filing deeply into the nail corners may cause:

13

Which of the following components measures the volume and density of the incoming air?

14

What are some of the features of today's engine analyzer systems?

15

Technician A says part-time four-wheel drive systems are manually operated. Technician B says all four-wheel drive systems are automatically controlled without driver involvement. Who is correct?

16

What is the function of the part the technician is holding (arrow)?

17

Equilibrium is a state which results from balanced forces.

18

The frame or unitized body serves the following purposes, EXCEPT:

19

Water should be used to extinguish a gasoline fire.

20

The rate of current buildup is determined by the amount of counter-EMF that is induced in a coil of wire.

21

If you were managing in a shop using the MBO approach you would expect your people to _______

22

A P0132 DTC is being discussed. Technician A says that a defective HO2S could be the cause. Technician B says that an HO2S signal wire shorted-to-ground could be the cause. Which technician is correct?

23

Using Ohm’s law, calculate the amount of current that would flow through a parallel circuit that has a total circuit resistance of 1.2 ohms and a battery voltage of 13.5 volts. Show all mathematical calculations.

24

A hydraulic starting system will use this component as the equivalent to a battery in an electric starting system:

25

What resists the flow of current?

26

It is not necessary to support any suspension component when replacing a shock absorber or strut.

27

Coolant drained from the cooling system when replacing a thermostat or water pump should be ________

28

____________________, which does not conduct electricity, will reduce or stop the flow of current between the battery and the vehicle's electrical system.

29

The steering wheel hub attaches to the ________ of the steering shaft

30

An advantage to frame-contact, axle engaging, or pad lifts is that the wheels hang free, which makes it easier to perform tire, brake, and suspension work.

31

Flat-rate times are given in hours and ____________________ of an hour.

Find your answers, solutions and more...

We made it much easier for you to find exactly what you're looking for on Sciemce. Enjoy our search engine "Clutch."

Save a GPA. Donate your notes with us.

Quiz Mark 7- Trades & Technology - Automotive

Recent Packs