Trades & Technology - Automotive; Helping Quiz 3

9.75 + (-4.37 ) - (-2.5 ) - 8.45 =

What may happen if the knock sensor system provides excessive spark retard?

Technician Asays caster is the inward or outward tilt of the wheel measured from top to bottom and viewed from the front of the car. Technician B says camber is the backward or forward angle of the steering axis viewed from the side of the car. Who is correct?

4

The piston converts reciprocating motion into rotary motion.

5

A mission statement is ________

6

The type of fractions you are most likely to see are ____________________ fractions.

7

Find the indicated horsepower of a 280 in^3 engine which operates with an MEP value of 170 psi at 5000 RPM. Round to the nearest whole unit

8

Technician A says in a return-less fuel system, the regulator is located in the fuel tank. Technician B says in a return-type system, the regulator is located on the fuel inlet line. Who is correct?

9

Technician A says that clutch slippage can be caused by a warped clutch disc. Technician B says that slippage is the result of too little free travel. Which technician is correct?

10

A/C compressor oil is the same for both hybrid and non-hybrid A/C systems

11

Which is the preferred method for tire rotation?

12

Which of the following statements is LEAST-Likely true?

13

Today, most wheel cylinders are rebuilt, rather than replaced

14

Explosions are fast-moving air pressure waves that result from extremely rapid burning.

15

A five-wire actuator uses two wires to power the motor (power and ground) and three wires for ______________

16

Technician A says if the turning radius is not within specifications, tire tread wear is excessive while cornering. Technician B says a bent steering arm causes the turning radius to be out of specifications. Who is correct?

17

The degrees of crankshaft rotation in which both the intake and exhaust valves are open is called ____________________.

18

When observing WSS output with an oscilloscope, most sensors should produce ________

19

Three pieces of fuel line are needed to install a carburetor. The pieces must be 8 inches, 15 inches and 20 inches. How much fuel line is needed?

20

ASE certified technicians have at least how much experience?

21

What type of sensor is the transmission fluid temperature (TFT) sensor?

22

Repeated rear axle seal failure occurs in a rear-wheel-drive vehicle. Technician A says the axle shaft may be scored in the seal contact area. Technician B says the axle housing may be distorted in the seal mounting area. Who is correct?

23

Technician A says that some intake manifolds are plastic. Technician B says that some intake manifolds are constructed in two parts or sections: upper and lower. Which technician is correct?

24

____________________ module communication is used for modules capable of initiating communication on the serial data line.

25

A parallel circuit has three resistances: 10, 2, and 5 ohms. Circuit voltage is 14.5 volts. What is the total current flow of this circuit?

26

If the air tanks are not drained

27

A driveshaft is also called a ________

Find your answers, solutions and more...

We made it much easier for you to find exactly what you're looking for on Sciemce. Enjoy our search engine "Clutch."

Save a GPA. Donate your notes with us.

Trades & Technology - Automotive; Helping Quiz 3

Recent Packs