(+) Save a GPA. Donate your notes with us.

Loading...

Quiz Mark 5. Trades & Technology - Automotive

1
The switching valves on the AIR pump have failed several times. Technician A says that a defective exhaust check valve could be the cause. Technician B says that a restricted exhaust system could be the cause. Which technician is correct?
2
A viscous clutch, cone clutch, or a multiple-plate clutch are three types of clutches that may be used in a(n) _____ differential.
3
A two-trip DTC will be stored in the PCM memory when a fault is detected during a subsequent second trip, and the MIL will begin flashing.
4
Always wear ____________________ gloves when working with chemicals.
5
Buffing the nails with pumice powder is used to treat:
6
A dual-clutch transmission uses ________ clutches.
7
Some semi-independent rear suspensions have a solid inverted U-section channel connected between the trailing arms.
8
What is the proper tightening sequence for lug nuts?
9
How do you remove acrylic nail if client do not want to wear them any more:
10
Technician A says during transmission reassembly, end play checks should be measured. Technician B says before a transmission is disassembled, end play checks should be measured. Who is correct?
11
Technician A says if the battery is disconnected, the steering angle sensor may require initialization before the parking system will operate. Technician B says testing of all of the detection range of the sensors of the automatic parking system requires the transmission to be in REVERSE Who is correct?
12
Technician A says the lower the bin number is, the cleaner. Technician B says that SULEV has cleaner standards than ULEV. Which technician is correct?
13
The pressure control solenoid provides ________ fluid pressure with low amperage current flow.
14
When diagnosing TCS/ESC equipped vehicles, which of these tools is recommended?
15
What term describes a multiple choice answer designed to resemble the correct answer?
16
Technician A says an open in star network bus will affect all the modules on the network. Technician B says an open in a loop network will isolate a module from the network.
17
ASE-Style Multiple Choice ____ provides easy access to a user customized database of recycled parts and suppliers in North America.
18
Which of these ATC output devices provides a feedback signal to the electronic control module (ECM)?
19
What should be done if the fuel pressure regulator will NOT hold vacuum?
20
A low pitch rumble over 20 MPH (32 km/h) is likely caused by ________.
21
Some transmissions are designed to apply a clutch or a band without having to release another one. This type of transmission is called ________.
22
The A7 test includes what subject material?
23
Technician A says that one disadvantage of disc brakes is noise. Technician B says that disc brakes are easier to equip with a parking brake mechanism than drum brakes. Which technician is correct?
24
Fractured rod caps are used with which type of rod construction?
25
What is the purpose of the instrument voltage regulator (IVR)?
26
Explain briefly the difference between how a flexible fuel vehicle works and one that runs only on gasoline.
27
It is good practice to have a first-aid kit in the shop.
28
Using a torque converter smaller than stock size could result in ________
29
What precautions should you take when using a bead blaster?
30
How long can power be retained in the high voltage system once it has been disabled?
31
Most immobilizer system transponders do not use ____.
32
ASE-Style Multiple Choice ____ give logical steps for finding the source of problems.
33
Nitrile gloves protect your skin when working with fuels, solvents, and other chemicals.
34
What color container is used for R-1234yf refrigerant?
35
If paint is to be reduced 3:1:1 (the three parts are paint, and the remainder are reducer and hardener), and you need 762 ml of paint, how much reducer do you need?
36
The part of the tire that is just under the tread of a radial tire is called the ________
37
Some automotive electrical systems use a capacitor or condenser to ____ electrical charges.
38
Why do many port fuel injected engines use long intake runners?
39
A(n) ____________________ is a hex tool used to turn setscrews and capscrews.
40
Two technicians are discussing a fuel gauge on a General Motors vehicle. Technician A says that if the ground wire connection to fuel tank sending unit becomes rusty or corroded, the fuel gauge will read lower than normal. Technician B says that when the power lead to the fuel tank sending unit is disconnected from the tank unit and grounded (ignition on) , the fuel gauge should go to empty. Who
41
Technician Asays a master cylinder can only leak internally. Technician B says a master cylinder can only leak externally. Who is correct?
42
Whose law summarizes the ways in which a voltage can be generated by a changing magnetic field?
43
Most port fuel injected engines operate on how much fuel pressure?
44
All safety glasses should meet the standards set by ________
45
ASE-Style Multiple Choice To help force flash paints between coats, you would MOST-Likely warm the spray booth to about:
46
Which component of the returnless fuel system is located outside of the fuel tank?
47
Heat is transferred from the hot coolant flowing through the ________________ to warm the air flowing through the fins of the heater core
48
A growling noise is heard only when the driver exerts force on the clutch pedal. No noise is heard when the clutch pedal is up. Technician A says the pilot bearing is defective. Technician B says the input shaft bearing is defective. Which technician is correct?
49
Which of these is true about hours of service?
50
To provide some control on secondary damage distortion and to provide a much safer compartment for passengers, a unibody vehicle is designed with crush zones or areas at the front and rear.
51
The intake valve is usually 35%-40% smaller than the exhaust valve.
52
If 12 volts are being applied to a resistance of 3 ohms, ________ amperes will flow
53
Since the 1990s, most major automobile manufacturers have developed an electric vehicle (EV).
54
Which of the following statements is LEAST-Likely true?
Welcome to Sciemce, where you can ask questions and receive answers from other members of the community.
...