Let Quiz 3/Trades & Technology - Industrial And Skilled Trade

Which of the following are differences between truck radial and bias-ply tires?

If you hear thunder, the associated lightning is within earshot or _____.

When discussing the mounting of the drive pinion shaft, Technician A says that drive pinion shafts may be mounted in a long bushing. Technician B says that drive pinion shafts are held by two tapered roller bearings.

4

Heatdraws out the temper of hardened steels and significantly reduces the strength.

5

How is the cooling anticipator normally wired to the cooling contacts?

6

Hopscotching is the technique that requires you to start at a point with correct voltage and then move one lead at a time until:

7

Technician A says that a properly functioning LED light should produce mostly light energy from the electrical energy it consumes. Technician B says that light systems that produce the least amount of heat are the most efficient. Who is correct?

8

In a separately derived system, the equipment bonding jumper connects the _____.

9

¿Qué es un sistema D-X?

10

Contracts are enforced under which section of law?

11

All of the following are common lockout/tagout safeguards, except _____.

12

At high speed, a blower delivers 2,720 cu ft/min. This volume is divided equally among 16 ducts. Find in cu ft the amount of air that flows through each duct every minute.

13

Perform the operations indicated and round to three places: 156.45 x 10.62 x 0.21 =

14

The distance between fins is classified as the:

15

Because of the shape of its jaws, which clamp can spread clamping pressure over a wider area than the

16

Cuando debe bombear agua clarificada que contiene muy poca cantidad de arena de una excavación de 10 pies de profundidad, debe usar una bomba _____.

17

The lubrication of a motor at prescribed intervals can be accomplished using a _____.

18

Welding fluxes do not affect the penetration and contour of the weld bead.

19

A steam boiler's blowdown separator helps reduce corrosion and scaling downstream and also _____

20

The ideal angle for the welding torch is ____.

21

_______________ modules are used for torque control of the AC traction motors.

22

The tie-in of weld metal to base metal on a completed weld should be _____

23

Answer the following statement(s) true (T) or false (F)

24

How does the PCM control the EHI?

25

Two important purposes of cost control are _____

26

La causa principal de muerte por choque eléctrico es/son:

27

Using Fan Law 1 (shown in the image above), find the new volume of air delivered from a blower if the existing volume is 1,750 cfm, and the blower speed is increased from 850 rpm to 1,000 rpm. (Round your answer to the nearest whole number.)

28

When welding in the overhead position, spatter may fall into or on the nozzle and contact tube, which may ____.

29

What component is incorporated into a insulated heat sink mounted on the end frame assembly?

30

A blue-colored bearing can indicate _____ of the bearing

Find your answers, solutions and more...

We made it much easier for you to find exactly what you're looking for on Sciemce. Enjoy our search engine "Clutch."

Save a GPA. Donate your notes with us.

Let Quiz 3/Trades & Technology - Industrial And Skilled Trade

Recent Packs